Looks like i've got water coming in from somewhere - attached a pic of where it's pooling. This is the bottom right hand side of the boot by the rear...
BBM is a great way to go, and they are very thorough with their units. The other option is to swap to an Eaton M64 from a Mercedes, but I have yet to...
If it was the pump, and I went for the refurb option how much labour time is it to remove and fit roughly? Just so I can factor that in if I make an...
Other than checking mine for splits, I haven’t really seen a problem with the damper box , but if they are cheap enough I will just replace it, it’s...
The ABS pump unit can be had new from VW for well over €2500! Second hand ones can be around €100, bur there is no real way of knowing if they are ok...
I wondered about the light cluster and the seal. I've got some clear/red inpro clusters on mine and they've been on there a while, so the seal may be...
The normal culprits are the badges as they are not really water tight . However yours looks by the pic to be all in the corner . Check the boot seal...
Yeah, the sensors are easy to get, and the rear sensors are more expensive but in general this is no big deal. The pump unit however is hard to come...
Sounds like your ISV silencer box. I know the guys in the USA on the VR6 Vortex forum are quite keen on removing it. There are quite a few videos on...
Will remove the glove box (have cut the bit off that jammed).Yeah have seen that on the n/s panal did not know it’s for the abs. I think the abs side...
• 
