Tab Content
  • seanl82's Avatar
    2 Hours Ago
    I stopped going to TPS when they just wouldn't give any discount. Prices were literally exactly the same as dealer prices, and the dealer would give...
    6 replies | 96 view(s)
  • seanl82's Avatar
    15 Hours Ago
    seanl82 replied to a thread Rescued White VR! in General Car Chat
    The mk3 Golf one fits but has a different profile, so curves a little more. The Passat is a straight fit, and I think one from the Seat Ibiza of the...
    206 replies | 5097 view(s)
  • seanl82's Avatar
    15 Hours Ago
    seanl82 replied to a thread Rescued White VR! in General Car Chat
    If its the bit with the lifting arms for the inner trim, you're out of luck. You can use every part from a Mk3 Golf aside from them. Unless you...
    206 replies | 5097 view(s)
  • seanl82's Avatar
    16 Hours Ago
    Reservoir will look a little like its gaining water as it gets hot (just like normal water when it gets near boiling point) although not quite as...
    1 replies | 42 view(s)
  • seanl82's Avatar
    1 Day Ago
    I tried an offset spanner but the top plate still wouldn't allow enough access for a decent purchase. I ended up buying a cheap impact gun and that...
    12 replies | 208 view(s)
  • seanl82's Avatar
    1 Day Ago
    seanl82 replied to a thread G60 bleed screws in Drivetrain
    Pretty sure it's 11mm. Use a proper brake flare nut spanner if you can, or you'll risk rounding it off.
    6 replies | 98 view(s)
  • seanl82's Avatar
    1 Day Ago
    Did the cambelt come with the tensioner as part of a kit or did you buy separately? If a kit the send it back, if not then I'd try to buy one that is.
    3 replies | 43 view(s)
  • seanl82's Avatar
    1 Day Ago
    Oh yeah, forgot about that!
    791 replies | 66065 view(s)
  • seanl82's Avatar
    1 Day Ago
    Just sold. Wasn't you was it! :lol: Was on for £125 or offer. Didn't hang about!
    791 replies | 66065 view(s)
  • seanl82's Avatar
    1 Day Ago
    Spa turbo manifold on ebay at the moment. Just saying Mic.......... :twisted:
    791 replies | 66065 view(s)
  • seanl82's Avatar
    2 Days Ago
    seanl82 replied to a thread Lambda probe part no. in Engine Bay
    http://www.realoem.me/search/tvn/037906265B
    2 replies | 66 view(s)
  • seanl82's Avatar
    2 Days Ago
    seanl82 replied to a thread Matrix pleeeease in Wanted
    I got a premium one from GSF, turned out to be BEHR/HELLA. Good quality and perfect fit. I have heard GSF have changed to a different supplier of...
    15 replies | 223 view(s)
  • seanl82's Avatar
    3 Days Ago
    Wow good effort, thats an epic read! Thanks for the kind words mate, much appreciated! Hopefully it shapes up ok but don't think it'll be on par...
    1061 replies | 81382 view(s)
  • seanl82's Avatar
    3 Days Ago
    seanl82 replied to a thread Driver side Seat in Interior
    Oh right, I didn't realise it was that bad! It'll be a full strip down of the seat then I imagine. I'm sure you could fabricate something out of...
    13 replies | 196 view(s)
  • seanl82's Avatar
    3 Days Ago
    seanl82 replied to a thread Driver side Seat in Interior
    If the centre it of plastic isn't damaged, and if you have the little metal tension clip still on place, it should just push back on with a small...
    13 replies | 196 view(s)
  • seanl82's Avatar
    5 Days Ago
    seanl82 replied to a thread Bmc cda in Wanted
    There is a plastic pipe (trumpet) inside the airbox lower half. I removed this when I had the K&N panel filter in, but didn't think it made the...
    18 replies | 335 view(s)
  • seanl82's Avatar
    5 Days Ago
    Check the bulb holder. Theres a kind of spring pin at the centre that passes the supply when contact is made with the core on the bulb. The spring...
    4 replies | 110 view(s)
  • seanl82's Avatar
    6 Days Ago
    seanl82 replied to a thread Bmc cda in Wanted
    I don't think a huge amount, though I can't remember specifics tbh Rob. Have a search, it was a thread on here a while back iirc.
    18 replies | 335 view(s)
  • seanl82's Avatar
    6 Days Ago
    The E30 blades aren't flat, so give a bit more of an OE look. The benefit is in the spring tension on the arms, so they hold it to the screen better...
    20 replies | 374 view(s)
  • seanl82's Avatar
    6 Days Ago
    seanl82 replied to a thread Bmc cda in Wanted
    They aren't shouty when your just cruising at steady speed like cone filters, but you don't half get a great sound when you plant your foot! As...
    18 replies | 335 view(s)
No More Results

Statistics


Total Posts
Total Posts
5,344
Posts Per Day
2.67
General Information
Last Activity
11 Minutes Ago
Join Date
1st September 2011
Referrals
0

2 Friends

  1. clumpy1 clumpy1 is offline

    ⋆⋆ CF Donator ⋆⋆

    clumpy1
  2. StFoulis007 StFoulis007 is offline

    Newbie

    StFoulis007
Showing Friends 1 to 2 of 2
About us
We are the world's largest community for VW's Super Coupé! Be it 8v, 16v, G60 or VR6 (or maybe something else!), everybody's welcome! If this is your first visit, be sure to click register and fill out your details before you can post.
Help us
This site is run on donations.
Please help keep the forum alive!
Follow us
advertising & sponsorship
Are you a company looking for advertising that could benefits our users? For site & forum sponsorship, please see our dedicated microsite here.