dutch 0 Posted September 20, 2005 i don't think my heated seats are working...i'm assuming when you set them on 5 they should get hot.. :evil: is there a fuse or something that the seats run off? Quote Share this post Link to post Share on other sites
dutch 0 Posted September 20, 2005 also...should there not be some sort of indication when you move the switch to 1 that the seats are working..i.e a light or someting? Quote Share this post Link to post Share on other sites
dinkus 10 Posted September 20, 2005 http://the-corrado.net/wiki/index.php/F ... ated_seats ;) Quote Share this post Link to post Share on other sites
RW1 0 Posted September 20, 2005 The fuse is No. 14 , 10 amps on all C's 1988 to 1995. No indication on the dash when the knobs are rolled 1 - 5. Only you bum gets warm soon afterwards. But you do hear a quiet click of a relays from under the seat squab on the rear passenger side. If these work, the fault is in the seat itself. They are thermostatically controlled by an element in each seat. Two elements fitted, seat bottom and backrest. The elements are in series so if one fails they both go. If both seats have stopped working, are the connectors under the seats connected? . Quote Share this post Link to post Share on other sites
dutch 0 Posted September 21, 2005 i do hear a click when i roll the switch over to 1...but the drivers seat doesn't seem to warm up....the passenger one does seem to warm a bit..... Quote Share this post Link to post Share on other sites
RW1 0 Posted September 21, 2005 Seat element heater element or thermistor has gone u/s then. Follow the knowledge based repair link above for the driver's seat. . Quote Share this post Link to post Share on other sites
dutch 0 Posted September 21, 2005 cool..thanks... Quote Share this post Link to post Share on other sites
GIXXERUK 0 Posted September 22, 2005 can't you just check for continuity ? if so which wires loop through the element ? cheers Quote Share this post Link to post Share on other sites
