RIMnCHOP 0 Posted October 11, 2007 HELLO I NEED HELP PLEASE :? THE TOP HOSE TO THE RADITOR HAS JUST BLOWN OFF DUE TO A LOOSE JUBERLIE CLIP. THAT RESULTED IN WATER AND ANTIFREEZE FLOWWING OUT OF THE HOSE. IVE REFILLED WITH WATER AND ANTIFREEZ AND REPRESURED THE SYSTEM. BUT THE TEMPRETURE LIGHT KEEPS FLASHING AND WONT GO OFF?? BUT EVERYTHING IS WORKING NO OVERHEATING AND TEMPRETURE IS NORMAL. DOES THE LIGH NEED TO BE RESET OR SOMETHING AS MY MECHNICAL KNOWLEDGE ISNT VERY GOOD. MUCH APPRECIATED IF YOU COULD HELP IN ANYWAY 8) Quote Share this post Link to post Share on other sites
ben16v 0 Posted October 11, 2007 no reset check the connection to the level sender on the tank assuming the fluid levels ar ok Quote Share this post Link to post Share on other sites
RIMnCHOP 0 Posted October 11, 2007 have checked the levelsthey seem to be ok . will the car still be ok to run?? :? Quote Share this post Link to post Share on other sites
dinkus 10 Posted October 11, 2007 The light is for coolant level, not temperature. Check that the level is between the min and max markings on the header tank. If it is, then it could be the plug for the sensor is loose/disconnected/full of water. Otherwise it could be the sensor (2 metal prongs in the header tank) is dead. Quote Share this post Link to post Share on other sites
RIMnCHOP 0 Posted October 11, 2007 CHEERS DINKUS MATE WILL HAVE A GOOD LOOK IN MORNING AS IT WAS DARK AND TO BE HONEST IT WAS HARD TO SEE IF THE LEVELS WERE RIGHT :) Quote Share this post Link to post Share on other sites
n3p 3 Posted October 12, 2007 My temp light always flashes, which is quite annoying (will fix it when i can be arsed). Had no troubles though, just keep an eye on the actual temp dial until you get it sorted Quote Share this post Link to post Share on other sites
