OSV 0 Posted June 27, 2011 Apologies for asking such a straighforward question its simply that in my experience Corrado parts have a tendancy to break if not handled correctly and with care. So that said could someone offer advice as to how best to correctly remove the switch whilst minimising the risk of damage. Thankyou. Quote Share this post Link to post Share on other sites
domwells27 0 Posted June 27, 2011 I've always just prised the right hand side of the switch with a large flat bladed screwdriver, then the same on the other side until I can pull it out. Quote Share this post Link to post Share on other sites
Wullie 1 Posted June 27, 2011 I use a couple of thicknesses of masking tape on the trim where you lever the screwdriver to give it a bit of protection. Quote Share this post Link to post Share on other sites
Jim Bowen 1 Posted June 27, 2011 i take the dash apart around it and push it out from behind. think if you have the clocks out you can reach it Quote Share this post Link to post Share on other sites
RW1 0 Posted June 27, 2011 Take the fuse tray out. Put your hand up inside the dash behind the dash switch and push it out. . Quote Share this post Link to post Share on other sites
Supercharged 2 Posted June 27, 2011 Angle grinder will work too but I prefer RW1's method. Quote Share this post Link to post Share on other sites
