stevec14 10 Posted September 3, 2013 Hi All This has probably been asked before but here goes. I have the original badges for the back of my G60 that I would like to put back on. Definately do not want to use badge adhesive(heard it takes paint off) would prefer to use the 3M badge tape(double sided). Has anyone used or done this, and if so what type of tape do you recommend? Thanks Steve Quote Share this post Link to post Share on other sites
seanl82 23 Posted September 3, 2013 Are there no plastic tabs on the back of the badge that slot through the rear panel and are attached by the blue retaining plugs? Quote Share this post Link to post Share on other sites
robrado974 1 Posted September 3, 2013 No these are the same as the vr6 badges . I had mine put on with bonding glue . Quote Share this post Link to post Share on other sites
Jamie 1 Posted September 3, 2013 I've always used double sided body tape for attaching trim etc. Just make sure you give the area a good wipe over with panel wipe and use a heat gun or hair dryer whilst applying. Quote Share this post Link to post Share on other sites
stevec14 10 Posted September 3, 2013 Any idea what make tape you used? I know 3M do loads of different type tape all with different numbers width etc. Thanks Steve Quote Share this post Link to post Share on other sites
Jamie 1 Posted September 3, 2013 No sorry mate its just called body tape and I get it from Brown Brothers Quote Share this post Link to post Share on other sites
davidwort 0 Posted September 3, 2013 I bought trim tape from this seller, good stuff. http://stores.ebay.co.uk/WAYSIDE-ADHESIVES-DIRECT?_rdc=1 look under 'high bond tapes' Quote Share this post Link to post Share on other sites
