Leaderboard

New clutch master and slave fitted + a proper Hunter alignment over the last few days. The car is rejuvenated and useable again: tracks spot on and the clutch issues I had with juddering have gone away. The pedal was also not returning and sometimes the clutch was not fully disengaging. The place I took it to was local, recommneded by a local fellow Corrado owner, I'm really happy with the outcome, they are engineers rather than fitters. The workshop had a mix of old and new 911s, TVR, Fiat X1, Triumph or some sort, GTV6 80s Alfa, Citreon ZM and a Vauxhall Senator. The clutch master I supplied was a LHD version as RHD is obsolete, he made it all work and even refitted it after bleeding it up as the pedal sat too high and engineered a solution to make it sit at the right height. I'm sure many fitters would have just left the pedal and inch too high or worse still refused to work on the car. I asked them to give the car an inspection as I've done quite a bit of work with the axle and it got a clean bill of health. There was a note that the subframe has had a weld repair due to seized bolt in the past, which I knew about and have a replacement already refurbished to go on. It would have made sense to do this time around due to the alignment but I still need to purchase uprated ARBs and Vibra Technic engine mounts... a purchase that will have to happen after Christmas now.