radness

Hi Guys, My ABS system hasn't been working for the past 3 months and I wasn't really concerned about it as I know ABS isn't really that important or so I thought. Although my MOT was due I thought simply disconnecting the light and they wouldn't even notice the car had ABS. Anyway the guy asked me why my ABS light wasn't working and told me it would be a failure as the ABS system is very important on cars that come with ABS as they are missing valves and such which prevent the rear wheels from locking up and so on a car with ABS that isn't working it's quite dangerous... So that means my ABS system must be working :( Anyway, tried to source a part (my left front sensor is screwed) and VW tell me they don't sell them anymore! I really didn't want to buy from euro car parts or GSF as i hear you need genuine sensors or you'll have all sorts of issues. Please help me, my car has no MOT and i need it :(

one last question, is WIX a good brand to use? Sorry, i tried searching on the forum for wix but noting about weather it's a good brand or not to get. thanks for the response

037 115 561 Anyone know if this can be used in a 9a? Also is it advisable to change your oil filter with every oil change? my last one was a year ago.

Guys, My ABS light has been on for a while now I borrowed a good vagcom off a friend and purchased the 4 pin to OBI II converter and it gives me a fault on the engine; 520; Volume/Mass Air Flow Sensor G19/G70 - open or short to ground INTERMITTENT Anyway, when i try to access the "brake" area of the system - i assume it tries to connect to the ABS controller? well the first time i got a flash of the model of my ABS unit then it disconnected and keeps saying "trying to re-establish communication to car over and over, it's almost like the ABS unit is dead or a wires gone or something, is there anywhere obvious to check? anyone had this before? I'd really like my ABS to be working this time of year :)

i'd love one :)

Anyone? :confused4:

Hey guys, Need some assistance from you guys on the following I hope you can give me any advice you have :) Some back ground info; My 9a has 135k miles on it and has KR Cam, and that's it really. Recent replacements; fuel filter / timing belt / oil / oil filter done at 125k miles. 1. I have done some research on the 9a engine and i raised a query before that once my engine heats up it loses a lot of responsiveness and "feels" to me like it has lost about 30bhp. I have read old posts on other forums and no one seems to come to a conclusion or a fix after replacing countless things. Someone has suggested the flap inside the air box isn't closing once the engine warms up, would that really have much effect and if so whats the best way to test it? 2. This has only happened twice in the past 6 weeks, my engine just totally dies , no judder or jump like when it is about to stall just totally gone dead and takes me by supprise, i have only ever noticed this when slowing down to take a corner, i'm a bad driver and usually have the clutch fully down when im slowing down so i know it's never to do with being in the wrong gear. It happened the other day and took me be supprise before i took a corner and i went over to the wrong side of the road as the power steering and all had gone. The engine restarts fine after this. 3. At 135k miles what would you recommend i service? I'm looking to purchase; NGK spark plugs part number; BKUR7ET WIX oil filter and 10/40 oil As part of this service I'm thinking about getting a new fuel pump, is ebay the best bet for a fuel pump? i really dont want to spend a ton of money. Does the fuel pump in the tank itself need replaced? i've seen on ebay some fuel pumps supporting 500bhp if used in conjuntion with the intank fuel pump or only 400bhp if used solo. Would it be a good idea to buy this pump and use it solo and disable the in tank pump? Again, thanks for reading my post and for offering any advice, sorry if i ask some stupid questions :)

Hmm I found a loose nut on the actual pump itself, it was loose and i was able to tighten it a bit with my fingers and some pliers, don't know how im going to get my hand in there and tighten it properly without the help of a ramp :(

Hey, I had a quick look under the car as i noticed a puddle this morning. It appears the Powersteering pump is leaking , the dripping is actually coming from the pump itself and it's sprayed around a lot of the engine so i guess it spews out faster when the engine is running. I also checked the fluid level and it's below min now and i usually keep an eye on this. Whats the most common cause for a leak in this area? pump failure? or seal/gasket? I did notice that when turning the pump was quite noisy but always put it down to it being an old car (now has 140k miles on it) If i need a new pump (i assume i do) is it a big job to replace? and wheres best to buy one?

just thought i'd update; yup drainage hole FILLED with rust. I basically found the drainage hole by feeling inside the wheel arch, it's over to the slight left of the fuel cap, stuck a small screw driver up it a few times and cleared out all the crap. drains wonderfully now. thanks :)

hmm... had about a 15 mile journey today (most i really ever drive) felt the relay 67 and it just felt a tiny bit warm (like +1-2 degrees more than the rest)but far far far from being hot. Perhaps you have a little short in yours or it's almost dead and is drawing a lot more current than it should? let us know what happens with it

is it relay hot or really hot? lol :grin: I couldn't resist - but hey, i'll check tomorrow and let you know :)

Hey My front left wing is pretty rusted and the pant has come off, the other side seems fine so im not sure what happened it :confused4: Anyway, Someone has offered me one for sale, he's only able to give me a chassis number so im unsure how to work out what year of corrado it's from, is there a difference between late and early wings/ or is it only the bonnet thats different?

thanks for the suggestions, never knew about that drainage hole, must be badly blocked for me to not even notice it Any way to remove the rust on it though ? i don't fancy sanding it down considering lol

If it rusts over and i can't put the fuel hose in and my poor engine won't start ;) thanks for the move buddy