stereoflaver

as above please, top number or the location on the fuse board. HELP !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

I've just fitted this one to my 16v' I had to use M6 bolts as the master had M6 holes instead of having M8 studs fitted into the master like the old one did. As for the pipe I just re-routed it to suit.

The rapid relay noise happened when the battery had charge, now the battery is flat there is a different relay pulsing. Which is the ecu relay so I can rule it out. Could it be the ignition switch ? HELP !

Which is the ecu relay ? Is there an other relay that I could swap to rule out. pics if possible or link to thread would really help.

The relays in the engine bay have now stopped clicking. I've got fuel to the metering head from the pump but not out the top to the injectors when cranking. now the battery is flat. please help !

The corrado is cranking but not firing, fuel pump primes and theres power to the coil. If I leave the ignition on the for a while the pump primes again and some relays in the engine bay start clicking on off really fast. Then while I was just sat, the rev counter jumped also there was a beep, 3 different beeps pause then 3 of the same different beeps. Its only been stood while I waited for a clutch master cylinder, got that fitted n bleed now it wont fire up ! HELP !! GGRRRRRRRRRRRRRRRRRR!!!!!!!!!

Any pics of where this 30amp fuse is ?

My corrado is off the road waiting for a clutch master cylinder. This morning I went out to remove the under dash and found the drivers side front n rear carpets resembling small lakes its parkedon the drive, drivers side down slightly nose down. Could this be the sunroof seal with as its old, dry n cracked with blocked run off pipes ? also there is a pool of water under the engine ecu near the heater blower. I pulled two big handfulls of leaves out from round here but the water is still there but the carpet under the blower is dry.