Jump to content

90radog60

Members
  • Content Count

    4
  • Joined

Community Reputation

10 Good

About 90radog60

  • Rank
    Newbie
  • Birthday 09/18/1973

Converted

  • Location
    Castle Rock, CO

Converted

  • Interests
    My Corrado, computers, music

Converted

  • Occupation
    Lead Network Engineer

Converted

  • Plus One
    On
  1. When mine went blank I had disconnect the brown ground wire under the hood. Reconnected the ground wire and now it works.:cheers:
  2. From the symptoms that you describe, it sounds exactly like the problem that I just encountered. Turns out it was my plug wires. Make sure that you have a good charge on your battery and disconnect the 2 wires on the back of the alternator. Then try and start the car. After disconnecting the wires I really had to pump the gas pedal to get it to start. Once I got it started it would start fine every time with the alternator disconnected. Like you I also lost power and was never able to rev above 1500 rpms. If your plug wires are bad and arching to the head it is sending this voltage to the alternator and killing the car.
  3. Well last night I finally figured it out. Turns out the problem was with my Nology plug wires. I determined that the failure was dielectric breakdown of the insulation resulting in a "Burn through" which provided the high voltage spark a direct path to ground. Once the high voltage had an easier path to ground than the spark plug gap the capacitive effect of the wires created multiple sparks during the duration of the ignition coil discharge time. This voltage was then being passed directly to my alternator.
  4. A few weeks ago while driving my Corrado home from work it started to loose power. I made it home parked it in the garage and checked a few things that evening. I looked at the air filter to make sure it wasn't plugged (K&N in factory air box) and it looks clean. I turned the key and could hear the fuel pump hum. I then restarted the engine and it ran rough with no power until it finally died. I turned the key to the on position and checked the ISV and it was humming like it should. Just for good measure I took it out and hit it with some carb cleaner. Still no change and will not start now. Next I thought timing, so I turned the engine to TDC and repositioned the distributor. Still no luck. Next I broke the cardinal rule and started throwing parts at it. So far I have replaced both fuel pumps and fuel filter. $300, I replaced the battery (Optima Red Top) $200, I replaced the alternator (I upgraded to 140 amp Bosch) $200. Here comes the weird part. While replacing the alternator I discovered that with the alternator in place and the wires disconnected I could start the car. It runs beautifully while running off of the battery. This tells me that all my wiring is good, distributor and hall sending unit, coil, DIGI are all good. I then hooked up just the big wire from the alternator to the starter, still fires right up. I then hooked back up the blue wire to the alternator and the problem reoccurs once it excites the alternator. I can rev it to 1500 rpm and then it dies and is really hard to get it to start again. I checked the blue wire terminal down by the starter and it looks fine. Has anyone ever encountered this problem or have an ideas as to where I should look next?
×
×
  • Create New...