julianhh 0 Posted March 7, 2005 Hi folks, Please could someone tell me where this is and whether it is easy to unplug and take out for a no lag chip to match a 68mm pulley. Best J [bringing my g60 back to life] Quote Share this post Link to post Share on other sites
vr6storm 0 Posted March 7, 2005 if its in the same position as the VR's one then its on the bulkhead/firewall of the engine compartment( on the n/s roughly) Quote Share this post Link to post Share on other sites
G60Jet 1 Posted March 7, 2005 its a fiddly job, but its easy to do. but if you dont know your way round the ecu i wouldn't even open it, get someone to do it for you. Quote Share this post Link to post Share on other sites
Tempest 0 Posted March 7, 2005 There is an excellent write up with loads of piccies on a German site, that I once printed out to replace my chip, alas the site's in German. But just in case the piccies are sufficient, it's here. Tempest Quote Share this post Link to post Share on other sites
julianhh 0 Posted March 7, 2005 Thanks folks. J Quote Share this post Link to post Share on other sites
h100vw 0 Posted March 7, 2005 I think theres a how to on http://www.snstuning.com Gavin Quote Share this post Link to post Share on other sites
