DaveVR6 0 Posted September 28, 2005 I know theres loads of posts similar to this... sorry! The standard vr6 speedlines are 15" ET43 and 6.5" wide (165mm). right. the wheels im looking at are 17" ET35 and 7.5" or 8" wide (190 or 205mm), but require a PCD adapter that is 20mm, so the new ET is 55, right?? Am i right in thinking that when theyre on the wheels will only stick out a further 12mm than the speedlines?? Also, are 20mm adapters safe? doesnt seem like a lot to hold the wheels on! Quote Share this post Link to post Share on other sites
Henny 0 Posted September 28, 2005 nope, et35 + 20mm spacer = ET15... Quote Share this post Link to post Share on other sites
DaveVR6 0 Posted September 28, 2005 I thought ET was the offset from the centre line of the wheel?? Quote Share this post Link to post Share on other sites
gibber 0 Posted September 28, 2005 IT is, from the centre line of the wheel to the mating face, there for is you plus materail on that face with a spacer the distance gets less. Quote Share this post Link to post Share on other sites
DaveVR6 0 Posted September 28, 2005 i think i get it.... so if a wheel had an ET of 0 then the mating face of the hub would be exactly in line with the centre of the wheel?? Quote Share this post Link to post Share on other sites
DaveVR6 0 Posted September 28, 2005 i seeee... cheers. So those wheels totally wouldnt fit! haha aww :( Quote Share this post Link to post Share on other sites
