Engine loom wiring/connectors question

[aussieg60 0]

I have an engine wiring loom from a 89 G60 Corrado. I am installing the G60 engine in my 1990 8v Digi2 Golf GTI. The loom that leads up to the ECU has 2 seperate wiring connectors in parallel that I dont know where they go. My Digi 2 also has 2 connectors different to the G60 loom and I dont know how to retrofit the G60 loom into my car. Does anybody know these connectors and what they do ?

The G60 loom below (the 2 connectors I am questioning)

The Digi 2 loom below. (1 connector goes to the transistorized ignition circuit mounted on a heat sink on the ECU bracket holder)

[Pau1 0]

Looks like your MAF conector and maybe the Lambda probe too ???

Im sure someone will be along later to tell ya. Good luck.

[aussieg60 0]

Do the G60's use the TCI-h or is it within the ECU ?

I also find the G60's ECU doesnt fit in the ECU bracket/holder as the heat sink is larger and the vacuum connector is sticking out.

[aussieg60 0]

Look like no one knows that answer to my initial question about the loom. Possible try another forum ?

[flusted 0]

the g60 doesnt use tci. Dont think those plugs are on the digi 1 loom either