radodale 0 Posted August 27, 2007 Have put some 16 by 9 inch brock wheels and was wrongly advised by the shop as to the needed and the wheels are slightly too wide and rub on the arch. As such i am looking to get the inner face of the wheels milled off in some way to bring the wheels in slightly. Does anyone know where this can be done? I am based in hHalifax West Yorkshire but will travel to get sorted out. Thanks very much for help. Quote Share this post Link to post Share on other sites
94 SLC Storm 10 Posted September 7, 2013 Your best bet is to roll the fenders and Quarter panels out a bit or if that doesn"t work then just sell them and put back your Steelies and be at peace! Quote Share this post Link to post Share on other sites
