coullstar 0 Posted January 29, 2009 Tried doing a search on this but I dont think its working right. Will be replacing the rear brake set up soon and getting ready for the carrier bolts from hell. When I get them out I'll make up some hi tensile hex head replacement bolts through work but does anybody know what size / pitch the thread is for these bolts and even better what the thread legnth is? Quote Share this post Link to post Share on other sites
davidwort 0 Posted January 29, 2009 the allen head jobbies are M10x1mm thread 25x20 splash shield ones to hub/axle are M10x24 Quote Share this post Link to post Share on other sites
Critical_Mass 10 Posted January 29, 2009 Coulstar - I found i couldnt shift them with the allen key, so used an irwin bolt gripper on a wrench and an extension bar. Quote Share this post Link to post Share on other sites
coullstar 0 Posted January 29, 2009 Coulstar - I found i couldnt shift them with the allen key, so used an irwin bolt gripper on a wrench and an extension bar. :lol: can you guess what I bought at lunchtime then....Ive been near these things before. Quote Share this post Link to post Share on other sites
Critical_Mass 10 Posted January 29, 2009 You know what you're in for then. :lol: They're b*ggers arent they!? Quote Share this post Link to post Share on other sites
KipVR 1 Posted January 29, 2009 just remember to put copper slip on the replacements! Quote Share this post Link to post Share on other sites
Critical_Mass 10 Posted January 29, 2009 and make sure you do them up tight enough. I had an incident with the bolts coming loose whilst i was drive - dragged the caliper round and into the splash guard and bent that to hell and i was left stranded until the RAC came out to take me home :( Quote Share this post Link to post Share on other sites
