DIGGER B 0 Posted May 23, 2011 Hi chaps need to connect the loom for my electric recaro only a live and earth but whereabouts in the fuseboard and what size fuse ? thanks Quote Share this post Link to post Share on other sites
AlexK 10 Posted August 13, 2011 Hi there. Stuck with the same. Could someone please have a look on his own fuseboard and give us advise? thanks! Quote Share this post Link to post Share on other sites
RW1 0 Posted August 13, 2011 All Corrado factory fit Electric Racaros run off their own fuse. It never changed from 1989 to 1995 how it was wired and fused. If the seats were fitted, the fuse was fitted in one of the spare slots above the two main relay rows on the fuse/replay plate. Similar position to the Central Locking fuse 20 amp (yellow) in a dedicated fuse holder. If originally not fitted, there will be no fuse slot or wiring. So to wire up..... The supply before fusing in the factory build is taken off connectior Y position, pin 1. This is a connection to busbar 30 which is the battery supply busbar. The Y connection on the back of the fuse/relay plate is the horizontal set of 4 heavy duty male connections. This is located in the top right corner as you look at the fitted fuse/relay plate while sat in the driver's seat. Pin 1 is the furthest from the side edge. Its obvious its the connection as it will have a very heavy duty red wire in pin 3. Rather than try replicate the fuse on the plate, fit an in-line fuse holder to your seat loom and then take an additional short wire which can carry 20 amps to the connection Y, pin 1 and connect. Fuse rating on factory fitted fuse is 20 amps. . Quote Share this post Link to post Share on other sites
