timbreen 10 Posted February 5, 2013 Can anyone please tell me if the vr6 wishbones are the same size/fitment as a 16v wishbone Quote Share this post Link to post Share on other sites
quicky1980 0 Posted February 5, 2013 different Quote Share this post Link to post Share on other sites
Supercharged 2 Posted February 5, 2013 Completly different as the VR uses 'Plus' suspension Quote Share this post Link to post Share on other sites
timbreen 10 Posted February 5, 2013 i have a vr6, but basically i have changed the set up, vr6 drive shaft into 16v boot, cv joints, hub, disks etc, but i have had to redrill the vr6 wishbone to fit 16v ball joint, would a 16v wishbone fit into the subframe? so i wouldn't need to redrill. Quote Share this post Link to post Share on other sites
davidwort 0 Posted February 5, 2013 No, but more importantly why are you using 4 cylinder bits on a vr? Quote Share this post Link to post Share on other sites
timbreen 10 Posted February 5, 2013 the wheels im wanting to run aren't clearing the vr6 carriers Quote Share this post Link to post Share on other sites
Supercharged 2 Posted February 5, 2013 Ehhh???? Quote Share this post Link to post Share on other sites
sexybourbon 0 Posted February 6, 2013 Would wheel spacer not solve the problem ? Quote Share this post Link to post Share on other sites
timbreen 10 Posted February 6, 2013 tried wheel spacers its out by about 35 40mm Quote Share this post Link to post Share on other sites
sexybourbon 0 Posted February 6, 2013 But you will be taking away the wide track ! Surely they was designed with that for a reason and changing its goin to effect the handling Can you not do it any other way other than that it seems like a right farce just to get a wheel to fit , each to there own like but that seems like a lot of hard graft for some wheels Quote Share this post Link to post Share on other sites
