Volts/Oil pressure gauges -- What else do I need

[VR6 Lee 0]

I have got the gauges but what other parts do I need?

 

Just wondering where the best place to get the bits I need so I can fit them in over the winter months

 

Many thanks in advance

 

Lee

[Wesleyvr6 10]

Lee, you can get the dual pole sender from Berlin Motorsport, the connector for the back of the gauges and 2 repair wires can be bought from Vw/tps. Dead easy to fit.

[VR6 Lee 0]

Lee, you can get the dual pole sender from Berlin Motorsport, the connector for the back of the gauges and 2 repair wires can be bought from Vw/tps. Dead easy to fit.

 

Are they specific part numbers?

 

Where you based in Stockport?

[VR6 Lee 0]

Lee, you can get the dual pole sender from Berlin Motorsport, the connector for the back of the gauges and 2 repair wires can be bought from Vw/tps. Dead easy to fit.

 

 

Take it you meant merlin motorsport

[Wesleyvr6 10]

Haha yes! Stupid iPhone!

[VR6 Lee 0]

Haha yes! Stupid iPhone!

 

No worries

 

Which sender, there are loads of types

[Wesleyvr6 10]

Yes I'm Stockport, bought your wheels remember! I will have to dig my invoice out mate to get the part numbers.

[jscVR6 0]

I got my oil pressure sender from VW Heritage, found they were the cheapest:

 

http://www.vwheritage.com/vw_spares_Oil-press-sender-150psi-Gauge-6-9psi-switch-2-pin_act_shop.product_pID_90289_lang_EN_country_GB.htm

 

And I think the connector is still available from VW:

1J0 972 704 Connector housing x1

000 979 133E Connector pins x2 (come as 2 pieces of wire with a pin on each end so you need 2 and cut in half to make 4 connectors)

[VR6 Lee 0]

I got my oil pressure sender from VW Heritage, found they were the cheapest:

 

http://www.vwheritage.com/vw_spares_Oil-press-sender-150psi-Gauge-6-9psi-switch-2-pin_act_shop.product_pID_90289_lang_EN_country_GB.htm

 

And I think the connector is still available from VW:

1J0 972 704 Connector housing x1

000 979 133E Connector pins x2 (come as 2 pieces of wire with a pin on each end so you need 2 and cut in half to make 4 connectors)

 

So everything for the above is for oil pressure and the volts bit??

[jscVR6 0]

Yep that's everything you should need, although you might want to order a couple of speed nuts that clip into the centre console to screw the gauge panel into p/no N90282501.

 

Wiring is as follows:

 

G. Druck = Pressure sender feed

15 = Ignition live

31 = Earth

58 = Dash illumination

 

There's all the information you need on this thread too:

http://the-corrado.net/showthread.php?t=13167&highlight=VDO+Gauges