2.0 16V ignition

[Stifko 10]

I apologize for my ignorance of

English, Google translator to help me, I

am from Czech Republic I bought

Corrado and the next morning I

images. When you first turn the

engine started, after a while began to

go irregularly on 3 cylinders and

filling. then he did not go start. When

you wait a minute, approx. 2-3

minutes it starts again again for a few

seconds. Candles are wet, so I guess

that to dry thoroughly so it starts. I

put the car into the garage to heat, I

opened the distributor cap and it was

wet, cleansed I have contacts,

degreased and had everything worked

as it should. This morning I will come

again and the same thing starts, after

a few seconds. will go to 3 War and

off. Then again it do not start. Not

after all normal humidity to go to the

distributor?

Edited October 26, 2014 by Stifko

[loepan 11]

first things first I would change the distributor cap

its hard to understand the google translate

 

První věcí, první bych změnit víko rozdělovače

jeho těžké pochopit,Google

[despercorrado 10]

you need to determine if the misfire is on just one cylinder. with it running pull the ht leads off the "candles" one at a time, if one comes off and no change occurs to the engine this is the problem cylinder.

there should be no water near the distributor. dry this out, it should stay dry, a small squirt of wd40 will help.

check for air leaks on inlet side.