Dreadyedge 10 Posted November 25, 2014 Hey all after a bit of help, I'm going to replace the ECU temp sensor on my 2.0 16v (9a) as it was suggest to me it could be responsible for the rough idling when 1st started and hesitation when accelerating until its warmed. He showed me which one he thought it was and its on the right side of the head just down from the dizzy and its a 2 pin plug one..is this the correct one and could anyone tell me an exact name for it and product code as the place I'm trying to order from can't seem to find it on there computer A PIC would be great if anyone has one so I can make sure I'm getting the right one, I have some of mine but can't seem to find any way to upload it sorry Thank you all :) Quote Share this post Link to post Share on other sites
Hairyarse 10 Posted November 26, 2014 Is it this one you're after? Quote Share this post Link to post Share on other sites
Dreadyedge 10 Posted November 26, 2014 That's it buddy Quote Share this post Link to post Share on other sites
davidwort 0 Posted November 26, 2014 I'd get your injectors tested (pull from head and just spray into bottles to view the spray pattern), poor atomization is always made worse when cold and old kjet injectors can have pretty rubbish spray patterns at idle once over 100K miles Quote Share this post Link to post Share on other sites
Hairyarse 10 Posted November 26, 2014 That's it buddy I'm pretty certain it's part no 36 on here - http://www.partsbase.org/vw/corrado-cor-eu-1995-212-oil-pressure-switch-thermal-switch-temperature-sensor-switch-for-reversing-light/ - in which case part number is 0269061061 I think mine was about £6.00. It didn't sort my running/stalling issues though, it turned out one of the lambda wires was broken Quote Share this post Link to post Share on other sites
davidwort 0 Posted November 26, 2014 I'm pretty certain it's part no 36 on here - http://www.partsbase.org/vw/corrado-cor-eu-1995-212-oil-pressure-switch-thermal-switch-temperature-sensor-switch-for-reversing-light/ - in which case part number is 0269061061 I think mine was about £6.00. It didn't sort my running/stalling issues though, it turned out one of the lambda wires was broken I don't think the lambda sensor is used until the engine is up to temp, it's usually hot idle probs with the lambda, but it may affect cold running if the ECU goes into limp mode because the lambda is dead. Quote Share this post Link to post Share on other sites
Dreadyedge 10 Posted November 26, 2014 Car isn't even on 100,000 yet and had an engine rebuild by previous owner due to snapped cam belt and I think it had new injectors and valves etc... So shouldn't be injectors Lambda sensor is a possibility 1st things I was going to try was the coolant sensor then the cold start injector Quote Share this post Link to post Share on other sites