cmck32 10 Posted May 8, 2017 Cool il try and work something like that then Sent from my iPhone using Tapatalk Quote Share this post Link to post Share on other sites
Jim Bowen 1 Posted May 8, 2017 Gets rid of a few crappy bits of pipe that end up leaking oil everywhere Quote Share this post Link to post Share on other sites
cmck32 10 Posted May 13, 2017 would this work?? Sent from my iPhone using Tapatalk Quote Share this post Link to post Share on other sites
cmck32 10 Posted May 15, 2017 Bump Sent from my iPhone using Tapatalk Quote Share this post Link to post Share on other sites
gazvr6 10 Posted May 16, 2017 Hi cmck32, 13mm inlet/outlet on the catch can are too small. I pretty sure you need 19mm mate Sent from my iPhone using Tapatalk Quote Share this post Link to post Share on other sites
cmck32 10 Posted May 16, 2017 Sent from my iPhone using Tapatalk Quote Share this post Link to post Share on other sites
cmck32 10 Posted May 16, 2017 So one of these 2 u think Sent from my iPhone using Tapatalk Quote Share this post Link to post Share on other sites
gazvr6 10 Posted May 16, 2017 Something similar to the top one. You can re-route pipework back into the inlet or use a breather filter like Jim has above. Be aware of the angle of the barbs though, as it may be more difficult to get it to mount and look alright. As you can see on Jim's, the inlet and outlet are on the same side and it looks like it's supposed to be there. Hope this helps? Sent from my iPhone using Tapatalk Quote Share this post Link to post Share on other sites
