Jimboslice

Who did your wiring?

It does say it goes up positive connection 1 (15), in interior wiring harness. But I have no idea where and what this is

I've already been through rubjonny's repository and I've basically now realised whoever has done the loom has put the 12v feed absolutely anywhere and I don't think I'll find it. Regardless I'm not getting 12v. I'll check my fuses and then I'll run a new 12v. Any recommendations on the best place for ignition live? The closer to the gearbox the better I guess

G1/4 is wired to the clutch switch which I don't even have. I've figured out it's wired for a mk4 so it goes from pin 1 on the vss BLK/WHT to t14a/2 BLK/GRN and then from there I can't find a diagram to help me locate. All I've got is it goes to b163?

I'll check G1/4 then thanks. It's a white/black wire from the connector so does it go to ECU and then to fusebox as a solid black? I hate auto electronics

Can anyone help me with this? I've narrowed it down to the VSS plug not giving me 12v ignition live. 5v signal works and ground has continuity. Does anyone know where the 12v comes from (G22)?

Well I don't know exactly where the other end of the wire goes to, ECU? In which case there's no way it's not plugged in. And I'm under the impression the ABS wheel sensor is irrelevant? The ECU gets its speed from the gearbox right?

Hi guys my speedo isn't working on my 1.8t AGU. The car was a 9a before with electronic speed sensor not the cable type. I've plugged in the gearbox connector and tried 2 different sensors and still nothing. Am I missing something? I've got code P0501/16885 and did have 00515 camshaft sensor but that has cleared and not come back.

Managed to sort it. Swapped the clutch over to a new one and it works. I've got a feeling it might of been the retaining clip as I didn't realise you're supposed to but the bottom bit on the fork as well as through the hole!

No problems with the flywheel then and I've got g60 flywheel bolts. I got it from eBay (I know I know) last year when I didn't know much about clutches.

Is a 9a flywheel the same as g60?

Swap my 02j for my old 02a and if that don't work buy a new clutch for a laugh. If that don't work set fire to my car and claim on insurance

You say that but I can drive up and down the drive on the clutch in gear. Got an 02j box, both 02a and j towers, 16v 9a flywheel, vr6 clutch, mk2g60 slave and braided clutch line direct between cylinders. I had the box off today and there's nothing out of place at all

yeah I've checked and it's straight! Has anyone had a gearbox that won't select gears? wondering if the syncro's are gone

My hydraulics have been proved to be fine. I've bypassed the hydraulics with a threaded bar to push the clutch fork in.