Hi, I want to do this conversion to my valver.
for a few reasons,
1. the starter motor fell off after I tried to start it one day, sheering both bolts off.
2. It makes long bangs sometimes pulling away in 1st
3. the slave cylinder needs replacing
4. Just because.
Anyway, I've been reading around the forum and I just dont have the room to fit the engine,
so quick run down, whats needed?
Can I keep the original gearbox?
What do I have to do concerning the loom and ecu? Completly replace it with a vr6 loom?
Also, does anyone in the exeter area fancy doing the conversion for me for a nominal fee?
thanks
