Lippy 0 Posted June 25, 2005 Would these fit into my car? Lippy Quote Share this post Link to post Share on other sites
ben16v 0 Posted June 25, 2005 audi ones??? i think they will with a bit of trimming! Quote Share this post Link to post Share on other sites
RW1 0 Posted June 25, 2005 Yep, audi ones. Will be a squeeze in the cubby hole below the dash if that's where you are thinking. Oil gauge when the engine is cold and first 2 - 3 miles will be hard over as pressure is above 5 bar at that point. Otherwise it will show 2 bar at idle and 4 bar at higher rpm. Centre guage, oil temp I presume will not really read much until the engine has warmed up as your 16v will operate at normally between 90 & 115. What are you going to do about the sensor bit. Take off the MFA wire and leave your LCD blank? Quote Share this post Link to post Share on other sites
Lippy 0 Posted June 26, 2005 they are from a mk2 golf gti, I think......... i was going to take off the oil temp bit and fit an air flow guage in its place. How much modding to the centre console is required? where is the best place to locate it? Lippy Quote Share this post Link to post Share on other sites
RW1 0 Posted June 26, 2005 One way is to make a shaped plywood with covering material to fit the centre cubby hole. Another is to take out the ashtray, bit of squeeze, I have previously used fibre glass printed circuit board as the mounting panel spray black or put in theh radio slot. Quote Share this post Link to post Share on other sites
