ECU question

[Critical_Mass 10]

Ive had a 68mm pulley fitted along with an SNS chip, however i didnt really see any benefit, i was later told i d need to get it setup properly on a rolling road. Would resetting the ECU to adjsut to new chip and pulley help? If so hows this done, simply disconnecting the battery?

[h100vw 0]

There is no reset for the G60 ECU mate. That's just for VRs. Ideally you need to set the timing and mixture again.

 

You do need to wind the motor up to see the extra power.

Gavin

[Critical_Mass 10]

yeah so ive been told. Ill have to get it sorted.

 

cheers Gav

[Supercharged 2]

If the car was runnig correctly, you should see a massive difference just by adding these 2, if not then the engine needs setting up and timing checked, doesn't need to be on a rolling road but it needs to be someone with experience of G60 tuning and someone who has a wideband!

[Critical_Mass 10]

a wideband?

 

was thinking JABBA ONLY because theyre closer then G-werks.

 

Im up in Leeds, any suggestions?

[h100vw 0]

Buy your own. Steveo29 bought one from ebay pretty cheap. PM him and say I said you should.

Gavin

[olly elworthy 0]

as a start set your ignition timing to 6 degrees BTDC and your co pot to 600 ohms, then get it tuned,,

I have a wideband,, but i`m in devon

[steveo29 0]

i paid about £175 for the widband kit......you could always sell it on once your done

[olly elworthy 0]

175 thats cheap, must of payed about £250 for my innovate LM1 with the import tax,,

well my mate did as payment for me doing a supercharger conversion on his integra,,,

[Critical_Mass 10]

arent sure what im doign so id rather someone else do it. someone who know what the ARE doing