Renewing G60 injector inserts

[mr.brown 0]

Hey folks, first post as I'm in the middle of a G60 conversion. Whilst I've got the engine in bits I thought it might be a good idea to renew the injector inserts.

 

I've tried a 10mm hex bit thru the centre but all I've succeeded in doing is rounding the hole out. Is there an easier way to do this or should I leave well alone?

 

Grateful for any advice.

 

Sean

[zerocool 0]

I used oxy acetlene,and warmed them(melted them) got them out,but had to run a tap down the threads again,as it damaged them slightly.

m20x1.5 tap,I think from memory.

to be honest bud,if they look ok,leave well alone,I only took mine out because I converted from digifant to kjet,and the seats are different for the injectors

[LowG 0]

If you have rounded the hex then use one of those tap star looking fittings, make sure its slightly bigger, hammer it gently and try it, they can be a bastard to take off.