Skimask 0 Posted September 11, 2007 Hi Folks, Just to confirm the timing marks on a VR6. The flywheel marks are: 0 | T - I gather its the vertical pipe mark that's TDC? Also - I couldn't find a timing mark on the crankshaft pulley (serpentine belt end) - there is an alignment mark on the block, but not on the pulley, is this correct? Cheers Quote Share this post Link to post Share on other sites
ziderapple 0 Posted September 11, 2007 There should be a very small notch in the crank pulley. Quote Share this post Link to post Share on other sites
Skimask 0 Posted September 11, 2007 There should be a very small notch in the crank pulley. Yes I know, but there isn't one there - and its at TDC according to the flywheel - if it is the mark between 0 and T. Quote Share this post Link to post Share on other sites
