G60 management on 16v

[kevyboy60 0]

Hi chaps

 

Got a bit of a problem,i am using G managment to run my 16vt the problem i have is that the water temp sensor for the guage on the G is a 2 pin and the one for the valver is a 1 pin , anyone know what i can do to get over this issue.

not sure what sensor an ABF uses ? is it a 2 pin style like the G with the seal and clip?

many thanks Kev.

[VEEDUBBED 0]

Been there with Digifart on my older T.16 2.0 corrado mills.

The 9A white headed water temp.sensor(2pin) will work fine,they are also excellent when using Weber/Marelli injection as i've got now,just don't use the shiyte blue headed Weber sensor,1.8KR Bosch sensor is also ideal but has a bigger thread compared to the 9A 2.0 sensor.

Only chip that was worth fitting was an SNS stg.5 version,all the others are total rubbish,Digilag was awful.

[kevyboy60 0]

Sorted thanks for that, 2 pin 9a sensor it is then.

I used to have a 280bhp g60 turbo before it took a liking to some trees,wrote the car off so decided to put the jabba ihi turbo kit on a kr engine,spoke to jabbas and they seem to think it will be good for 320-350bhp with 1.5 bar map sensor.

thanks again cheers kev.

[krnau 0]

Sorted thanks for that, 2 pin 9a sensor it is then.

I used to have a 280bhp g60 turbo before it took a liking to some trees,wrote the car off so decided to put the jabba ihi turbo kit on a kr engine,spoke to jabbas and they seem to think it will be good for 320-350bhp with 1.5 bar map sensor.

thanks again cheers kev.

you will post pics of that job won't you!? :notworthy: