ZackM8 0 Posted June 13, 2004 Can anyone give me a basic rundown on how to do this... I have an American corrado with my pod that fits on the drivers side side windshield thingy, and i have a boost gauge and voltmeter to hook up.... can anyone give me that basic rundown and easiest was to get that dash apart and such to make this work and the best hose to tap into for the boost gauge thanks Quote Share this post Link to post Share on other sites
vr6storm 0 Posted June 13, 2004 moving this into the "inside your interior" section,as its not strictly an engine mod as such :wink: Quote Share this post Link to post Share on other sites
G60Jet 1 Posted June 13, 2004 like this then Basically you need to mark up where the pod goes, remover the trim and screw it all together with the wire going into the trim and down the side of the dash into the fuse area, from there you can tap the volts and hock up the boost gauge to the dash instrument cluster Quote Share this post Link to post Share on other sites
ZackM8 0 Posted June 13, 2004 so I don't need to really take my dash apart? Quote Share this post Link to post Share on other sites
G60Jet 1 Posted June 13, 2004 a litle bit yes, the instruments need to come out, (easier if you remove the steering wheel) Quote Share this post Link to post Share on other sites
ZackM8 0 Posted June 14, 2004 now what is the best vacuum hose to tap into? can you take a picture of it ? and what is the easiest way to get that hose into the engine bay .... Quote Share this post Link to post Share on other sites
G60Jet 1 Posted June 14, 2004 you tap the boost gauge of the hose that goes to the cluster so there is no need to go into the engine bay Quote Share this post Link to post Share on other sites
