fazgti
-
Content Count
148 -
Joined
Everything posted by fazgti
-
ok m8
-
Cheers Beaker i will get on the coils, you've been a big help faz
-
Yea all the headlights are off in my garage now, wiring in the back of the headlights looks fine but it was raining HARD when i fitted the bulb :oops:
-
Just remebered that a few months ago it did go in the garage and the bloke said that one of the codes came up with a misfire on one of the cylinders (cant remeber which one), but then the bloke started going on about lambas and stuff :?:
-
Nope no boost gauge, (i dont have anything do i) it just had a full service aswell, it revs freely while standing it just acts up under load
-
Na that is on the to-do list very soon, not really sure what to do, spose i might have to do allthree that you mentioned
-
I will have to write the codes down cause i stuck it on the computer at the garage, the car idles fine and this problem happens at different times in the revs always changing, you could drive for a a bit and not notice it then it would happen a lot in a few minutes
-
Right checked the fuses and all fine, ended up taking the headlights and grill off to have a better look, yea i did try with ignition on lol, even the full beam does'nt work but it does on drivers side
-
i did think it could be a coil any way to check?, it does'nt run any different with the maf on or off, it does have a K+N cone
-
cheers Gixxer
-
Can anyone tell me which number fuse the passenger headlight is plz?
-
anyone?
-
yea i wil check the fuse
-
Right run the car with the MAF off and it made no difference, does that mean that it is faulty or it is not?
-
yea i will try that again but im not sure its that
-
The main beam bulb went so replaced it and now the whole passenger side headlight doesnt work at all
-
Using the green sensor and cant find any air leaks, yet to try the air flow sensor off
-
Cheers pete, do you reckon that pattern parts are good to use, i will check pipes and sender
-
AGU 2001 mk4 Golf engine Just for the two sensors vw want £210+ and if its not the problem then.... thing is if you clear the fault codes the problem of the car holding back goes away then returns when the fault code comes up again(bout 10mins up the road)
-
Took it to a vw specialist down here in Brighton and he said its the Lamba Probe and it also needs a Mass Airflow Sensor, now i am told these o alot on the 1.820vt engines but i found a receipt 6months ago for both these parts could they already be knackered in such a short time?
-
Greeny yours look the nuts, dunno know, might just go along with the set of 7.5's ive been offered
-
Cheers OSV thats made my mind up, no no
-
Just wondered if anyone has a pic of someone running 7.5x16 cause i have a chance to get a set but not really convinced, look a bit shallow compared to the 9'
-
I know i can get hold of the germen alloy plates, but does anyone know where to get normal acrylic plates but smoked i cant find them on any of the sites
-
Cheers gsbellew, looks a bit dated on mine nobody know where to get the smoked plates from then?