bosshogg

UPDATE I decided to fit standard rear disc and bearings to get over problem. re thread the disc wheel bolt holes is probebly not a safe option :shock:

thanx ,disc where drilled type £130 a pr cant be bought indervidual guess theres no cheap way out

Changed rear wheel and whilst doin up the wheel bolts three of em wont tighten up, so can i get them recoiled as i only fitted new rear discs last year or ? any help much appreciated :pale:

JAMEX COILOVERS Got them on my Rado they do the job, had to get 2 replaced under warrenty thru TSR seal blew. Tsr where great. Hard as hell for ride comfort,great for cornering and looks, be carefull when lowering otherwise to low i found stainless exhaust touches the rear crossmember.

Should be ok had to remove decat pipe for mot in jan, so hopefully no bad language required.

cheers for info,last car was a mk2 no worries about lamdas then :D

Time has come to change the lamda sensor,im running rich,plugs sooted up,tailpipe black. My question is how to change the sensor is it as simple as unplug, then unbolt and fit a new one or do we need VAG equipment to set up. The wiring was checked and is ok.

My corrado seems to have a whine (hum) coming from the drive area 20mph upwards only just noticable to me. I have fitted coilovers to a 40mm drop, changed gearbox oil vw go52 726 a2, and inspected box no signs of wear on drive shaft. gaiters all fine coilovers have been supertracked. Can drive shafts be under strain due to coilovers ? i.e on gearbox inner bearing wheelbearings seem to have no play any ideas chaps

Lamda wireing was cut at plug end to engine,tried to rewire but need another loom. could the lamda be damaged due to wires cut ? will i need to check the co2 again hope to resolve this weekend :)

Good luck tomorow dude, ive got flusted lookin under the bonnet :D he's the guru

Dont get rid of the car it holds too much sentimental value to you you will find a way Mine is not workin either but will sought out soon i hope 92 raddo 2.0 16v good luck dude 8)

Hey dude, sounds like the same symtoms/prob as my 92 raddo 2.0 16v i get started ok runs for 1/4 mile then dies to 500rpm then wont rev,then surge of power. LET ME KNOW IF YOU FIND THE PART NAME PSE.

Ok can u let me know if you resolve the problem

my raddo starts fine and drives ok for 1/4 mile then misfires jerks revs die to erratic low 500rpm across all cylinders, no power to pull away. Then if i remove the ecu plug spray WD40 on to the plug i get temporary power back for a 1/2 mile then it starts again,sometimes i keep the revs to 4000 and i can get it home.So far ihave replaced the following 4 x injectors dizzy cap rotor arm plugs bosch leads beru fuel filter to me its fuel starvation, but i dont get the ecu and wd40 bit ? any idea dudes :roll:

My Rado is suffering power loss during the first three miles of a trip out depress the accelorator hard in low gears and it will die then regain abit like lack of fuel followed by backfire noise but in mid exhaust, when warm it goes better but not perfect. Ive fitted new injectors, plugs(bosch super) any ideas