Heardy 0 Posted May 10, 2005 Can someone tell me which program i need for my OBD 2 interface lead i've looked on the rosstech website and there seem's to be a lot more version's than there was before when i downloaded it :? .Any ideas ? Thanks alot Jason Quote Share this post Link to post Share on other sites
h100vw 0 Posted May 10, 2005 I borrowed a lead from a mate and used the one to match the lead. HEX-COM can or something. Gavin Quote Share this post Link to post Share on other sites
Heardy 0 Posted May 10, 2005 That's what i'm not sure about Gavin.I've got a X-ONE OBD 2 lead and i'm not sure which one i need. Quote Share this post Link to post Share on other sites
dr_mat 0 Posted May 10, 2005 There's two main program versions on the VAG-COM site because the 3.04 (iirc) version is the LAST that works with the old opto-isolated leads. The newer leads use faster technology and the newer software releases take advantage of that. Your Corrado VR6 will work perfectly fine with the old VAG-COM and any old OBD-compatible lead. The C VR6 is an OBD1 ECU. The connector may be OBD2, but it's all OBD1 protocol. Quote Share this post Link to post Share on other sites
h100vw 0 Posted May 10, 2005 The one my mate got is a pukka VAG-COM lead. I guess yours is a third party one? If it is I'd try this page at the bottom...... http://www.ross-tech.com/vag-com/download/archives.html Release 311.2 If that doesn't work, then I'd try each one till you find the one. Best of luck Gavin Quote Share this post Link to post Share on other sites
dr_mat 0 Posted May 10, 2005 That's the one - 311.2. Works well for my generic OBD cable. Quote Share this post Link to post Share on other sites
Heardy 0 Posted May 10, 2005 Thank's for that i'll give it a go Quote Share this post Link to post Share on other sites
