StormchargedVR6 0 Posted August 4, 2005 I need to know TORQUE setting for the flywheel to crank Quote Share this post Link to post Share on other sites
dazzyvr6 0 Posted August 4, 2005 7.0kgm(50.5ft.lb.)then tighten a further 1/4 of a turn Quote Share this post Link to post Share on other sites
Taggart 0 Posted August 4, 2005 I'd tell you if I could figure out this bentley... all I see is the fly attaching to a toothed wheel to the crankshaft But it looks like 60Nm (44 ft lb) + 1/4 turn to me. Quote Share this post Link to post Share on other sites
StormchargedVR6 0 Posted August 4, 2005 Cheers guys, i go with 60nm + 1/4 turn. Fitting my lighten Flywheel tomorrow nite. :) Quote Share this post Link to post Share on other sites
dazzyvr6 0 Posted August 4, 2005 the figure i put was taken directly out of the peter rusek book. Quote Share this post Link to post Share on other sites
Taggart 0 Posted August 4, 2005 Mines from the bentley, looking again I'm sure it's right Quote Share this post Link to post Share on other sites
dazzyvr6 0 Posted August 4, 2005 dont forget bently is aimed at the us version which has less bhp than the uk vr6 Quote Share this post Link to post Share on other sites
Taggart 0 Posted August 4, 2005 Ah there you go, I can be in error occasionally :) Quote Share this post Link to post Share on other sites
W3RKD 0 Posted August 4, 2005 60 then a 1/4 is correct. Quote Share this post Link to post Share on other sites
Taggart 0 Posted August 4, 2005 Ah knew it, I'm never wrong ;) Quote Share this post Link to post Share on other sites
GIXXERUK 0 Posted August 4, 2005 XBones, :lol: :notworthy: Quote Share this post Link to post Share on other sites
