Jump to content
Sign in to follow this  
dutch

The problem is still there!!

Recommended Posts

Ok, just got back from Toronto the other day and I was hoping the Corrado would have healed but no luck...... :oops: I did a full service on the C before I left..plugs,leads,cap and rotor etc and she run good for a few days before it devolped this spudder. Between 1.5 and 3000 rpm it tends to hesitate...i'm thinking fueling problem but not sure...

the other thing is the C seems to have an annoying pull to the left and it's getting worse!! any ideas?

 

thanks

d

Share this post


Link to post
Share on other sites

VR....before I left a mechanic plugged in it but nothing was coming up...of course it was runiing fine then....will try it again...

Share this post


Link to post
Share on other sites

Since you've ruled out spark (well .. you've replaced all the relevant bits) it must be fuelling, but that sort of symptom is less likely to be lack of fuel, and more likely engine sensor issues causing the ECU to misfuel. Perhaps there's an air leak on the inlet piping, post-MAF? Could be the MAF itself, too.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...