craigowl 0 Posted January 11, 2007 On my 16 year old 205 diesel (1990) heater fan stopped operating. -got fan out and put 12v to it - it goes OK - no bad noises. -trying to get heater control panel (3 knobs) out today. As is often the case, Haynes ain't too helpful for me here. Question 1 - you dont have to get whole fascia off do you? Question 2 - which bit of the heater control panel will need to be replaced (local garage says you cant repair it - get new unit). Fan is not like polo with, say, 4 speeds but is variable speed from standstill to full on. Thanks in advance, guys, for any advice. Quote Share this post Link to post Share on other sites
DUB 0 Posted January 11, 2007 Sell it!!!!! :lol: Quote Share this post Link to post Share on other sites
craigowl 0 Posted January 11, 2007 :lol: Dont tempt me - have spent £600 on it since October! Determined to keep it as our daily runabout - still viewing it as an economical proposition. You would not believe its great general condition. No rust whatsoever, uncomplicated 1.8 non turbo diesel engine, etc. Quote Share this post Link to post Share on other sites
randomist 0 Posted January 11, 2007 my mate had a 205 gti many years ago & i vaguely remember his heater packing up! from memory it's a common fault on 'em & it ended up costing him a fortune & his father in law owns a garage! i think it's along the lines of a corrado heater matrix kinda job! soz for sounding vague but it's over 10 year ago, when i see him i'll ask him. Quote Share this post Link to post Share on other sites
craigowl 0 Posted January 11, 2007 Thanks, dood. I am just back indoors after putting it all back together again. I cleaned the rotating knob bit and the circuit board with a few squirts of "Clean tronic" and now the fan works! Worst bit was getting the heater control panel out of the dashboard - i think you are supposed to remove most of the fascia and possibly the steering wheel! - and then putting everything back together again. I applied a bit of leverage to plastic here and there, unscrewed about 16 screws and managed to prise the thing out a few inches enuf to spray it. Heating system works but disappointing to have 3 screws left for trim - bl00dy French! If nothing rattles I wont bother tracking dowmn where they go - this car doesnt owe us anything. Quote Share this post Link to post Share on other sites