JayGT 0 Posted June 9, 2007 Ok guys so I removed my early style gauges. and bought this passat climatronic wiring diags.pdf09062007139.jpg[/attachment:50c7e] behind the old gauge panel was this climatronic wiring-Golf from May 01.pdf09062007136.jpg[/attachment:50c7e] so how do I make these... 2.8l 24v Climatronic system.pdf09062007137.jpg[/attachment:50c7e] fit the back of the new pod which looks like this. 09062007138.jpg[/attachment:50c7e] Or do I have to bite the bullet and get a pro? Also the new pod came with an oil pressure sender, will that need fitting? I was under the impression it wouldnt as I had an oil pressure gauge in the old pod. Cheers Quote Share this post Link to post Share on other sites
vr6storm 0 Posted June 9, 2007 should be a case of changing the existing connectors to small spade female connectors,if you had an oil press guage before it should work with the new guages Quote Share this post Link to post Share on other sites
JayGT 0 Posted June 9, 2007 I hope its that simple. rear of the pod look like it accepts a VAG plug you find all over the car? Will it work if i get a few female connectors? Quote Share this post Link to post Share on other sites
vr6storm 0 Posted June 9, 2007 I hope its that simple. rear of the pod look like it accepts a VAG plug you find all over the car? Will it work if i get a few female connectors? my guage panel is the very same one you have and its got individual connectors hooked up to it(was fitted by a head VW tech as a casher),and 3+ years later I've had no problems other than the original guage's decals peeling off,so just get a few female connectors to fit and it should all be hunky dory Quote Share this post Link to post Share on other sites
JayGT 0 Posted June 9, 2007 Sweet i'll give it a go tomorrow. Just one other thing how do i know which connector goes where or is it just trial and error? Quote Share this post Link to post Share on other sites
vr6storm 0 Posted June 9, 2007 Sweet i'll give it a go tomorrow. Just one other thing how do i know which connector goes where or is it just trial and error? druck IIRC = oil pressure whats the rest of the panel say on the back???..........can't remember as it was last year I replaced my pod Quote Share this post Link to post Share on other sites
vr6storm 0 Posted June 9, 2007 more info here http://the-corrado.net/.archive/forum/viewtopic. ... uage+panel the instruction I had when I bought my first set were seemingly no use,the guy who fitted them didn't need them at any rate Quote Share this post Link to post Share on other sites
vr6storm 0 Posted June 9, 2007 ............page 8 of that link states "Top to bottom: Oil pressure Ignition live Earth Dash lights" Quote Share this post Link to post Share on other sites
JayGT 0 Posted June 9, 2007 it says: G Druck Kl.15+12v Kl.31 Kl.58+Bel Quote Share this post Link to post Share on other sites
vr6storm 0 Posted June 9, 2007 post above matey :lol: Quote Share this post Link to post Share on other sites
JayGT 0 Posted June 9, 2007 ............page 8 of that link states "Top to bottom: Oil pressure Ignition live Earth Dash lights" Sweet that should do me just fine! I'll be doin this with my cornflakes! :D Quote Share this post Link to post Share on other sites
