ross.taylor 0 Posted December 5, 2003 I need to take off my rear wiper arm to check the splines on the motor. But I have no ides how to do it. There is no obvious cap to take off to expose a nut like on the front ones, and the washer nozzle is right where a nut should be! Quote Share this post Link to post Share on other sites
Danger Mouse 0 Posted December 5, 2003 As far as I remember the whole plastic cover at the washer nozzle flicks up giving you access to the nut. Quote Share this post Link to post Share on other sites
Kevin Bacon 5 Posted December 5, 2003 Nice one DM as I need to do the same. Following my windfall at the dealer today (see lupo wiper thread) I will be fitting a lupo arm to the back too. I intend to remove the hinge pins from both the original rear arm and the lupo one and swap them over using new pins. I've already measured up and it's gonna look sweet :lol: K Quote Share this post Link to post Share on other sites
chuck 0 Posted December 6, 2003 as danger mouse says, the black plastic cap lifts up - kinda pivots up around the smaller end. But be careful not to break the plastic washer nozzle off, as this is what I was replacing, and iI can now say its a real awkward thing to do!!!!!!!! Quote Share this post Link to post Share on other sites
