awigman 0 Posted April 19, 2009 Just bought myself some new wheels They are 9j all round with ET15/25 Tyres are 215/40 R16 Will i have any problems running these, iv read i will prob have to get the archs rolled but is the ET correct? The car is currently sitting at standard ride height. Quote Share this post Link to post Share on other sites
swiftkid 1 Posted April 19, 2009 ET does sound a little bit low, may have to have some arch work to drop it low as they will have a bit of poke. Standard ride height i wouldn't have thought you'd have problems though. Quote Share this post Link to post Share on other sites
Jim 2 Posted April 19, 2009 They'll look decent.. a deep dish with a chunky 5 spoke. They look similar to the wheels Alex Pose-Gil used to run on his Corrado and that looked excellent! Quote Share this post Link to post Share on other sites
BigTartanJudge 0 Posted April 25, 2009 I ran 9x16" Borbet B's all round on my white G60 and they were ok, but I was running 205/40 all round and had arches all rolled. Quote Share this post Link to post Share on other sites
awigman 0 Posted May 6, 2009 just went to fit the wheels to find the center bore is too small. will i have to get a few mm machined off the inside of the wheels? where would i get this done? thanks Quote Share this post Link to post Share on other sites
yeti 0 Posted May 6, 2009 any wheel refurbishing place with a lathe big enough woulod be able to do it easily Quote Share this post Link to post Share on other sites
awigman 0 Posted May 7, 2009 does anybody know any where in coventry or warwickshire that will be able to do this? Quote Share this post Link to post Share on other sites
yeti 0 Posted May 7, 2009 dont know of any wheel refurb places local but this place is pretty local to you and they should know of somewhere that could do it http://www.midlandwheels.com/ Quote Share this post Link to post Share on other sites
