MarkGolf 0 Posted April 26, 2009 Hi, Whats the best way to wire these without it looking like a bodge job? Am I right in thinking that I need to join the 3 main live's to the fan live? cheers Quote Share this post Link to post Share on other sites
Kevin Bacon 5 Posted April 27, 2009 How many Spals are you running? Just join the lives together onto a peice of 20+ amp wire and then hook that onto speed 1 fan output wire. Join the earths together and screw to the chassis somewhere. Quote Share this post Link to post Share on other sites
MarkGolf 0 Posted April 27, 2009 Hi Kev, I'm running 2 9"s... Do you know what colour the speed 1 wire is? I know I have 2 thick and 1 thin live's.. Red/Green and red/? and the thin red/white... Cheers! Quote Share this post Link to post Share on other sites
KipVR 1 Posted April 27, 2009 I would recommend getting a 20amp waterproof connector from RS, the fans draw a lot of current and the non waterproof type supplied on the end of the fan would soon cause problems after a few months of wet English weather.... Quote Share this post Link to post Share on other sites
Kevin Bacon 5 Posted April 27, 2009 Do you know what colour the speed 1 wire is? I know I have 2 thick and 1 thin live's.. Red/Green and red/? and the thin red/white... Pretty sure it's the thick red/white one from memory. The thin one is the output for speed 2 and the red thick is the input voltage for the sensor. Quote Share this post Link to post Share on other sites
MarkGolf 0 Posted May 3, 2009 Cheers, all wired up but not tested as yet! A friend of mine who was round mentioned that I should just join all 3 wires together and join to the fan lives... He's normally very good with wiring so he has put some doubt into my mind.. :? Quote Share this post Link to post Share on other sites
