Rams 0 Posted September 4, 2011 Hi all I cant seem to work out how the fuse board clips work. The 2 white clips. I have lots of wires up behind it from the OBD2 install but there is room for it to sit level but I seem to be doing it wrong as its dropping down a bit. Any tips would be much appreciated. Regards Rams Quote Share this post Link to post Share on other sites
RW1 0 Posted September 4, 2011 Fuse box plate should sit into a frame with the two lower big supports into the frame. At this point the white plastic pegs go over the large supports on the outside of the frame and lock into the vertical position. There are indents up the side of the plate wall for this to lock the "tail" into. Best to push as much as possible the bundling of wires into the top right far back corner to ease the pressure on the plate. . Quote Share this post Link to post Share on other sites
Rams 0 Posted September 4, 2011 I had them in the horizontal position, maybe thats what Im doing wrong. Cheers RW1! Fiddly little beggars Quote Share this post Link to post Share on other sites
