Thumper 0 Posted August 11, 2012 (edited) This engine was removed from a G60 corrado that was known pretty well known over in Ireland, was owned by Barry and Gerhard from Vagdrivers. Has dyno print out for nearly 210bhp. The engine has a big spec and cost a fortune to put together, briefly: SNS Chipped ecu 68mm pulley Vernier pulley Gas flowed, polished and stage 3 ported big valve head 35mm valves and oversized valve seats ported manifold and throttle body 268 Schrick cam R1 Spec Polished and ported charger by G-werks (only 20k on it) TSR stainless 4 to 1 branch manifold 3.5 fpr red top injectors vibratechnics front engine mount Have pretty much all the receipts for the bits inc the crucial G-lader rebuild and headwork etc. The charger was split by local vw specialist JRM fabrications and checked over and its all A-ok! pricewise id like it gone asap so would like to sell in lots of parts as it were, the worked head with schrick cam and ported inlet/throttle body combo £400 R1 charger £380 vibratechnics mount £50 sns chipped ecu, red top injectors,fuel reg and charger pulley £140 rallye U bend with pipe and all important gasket & long bolt £95 idle control valve £20 alternator £30 distributor £40 Tsr manifold (right hand drive) has had bit welded on after flange for some reason but can be nipped off £175 inc lambda sensor in it bottom end £140 various other pipes, brackets etc etc just ask! Can post pretty much everything (bottom end might be bit tough on post office scales though!lol) Any questions just ask, not an expert at the prices but i THINK theyre close to the mark :) Edited August 13, 2012 by Thumper Quote Share this post Link to post Share on other sites
kerrly 0 Posted August 13, 2012 Hi, do you have any pics/receipts for the head work? Also, how much for the inlet manifold, throttle body, the FPR and the sensor which has a earth lead on the end of the fuel rail (cant remember the name for it) Dave Quote Share this post Link to post Share on other sites
Thumper 0 Posted August 13, 2012 Hi Dave, have the receipt on file for the headwork which cost £540 if I remember correctly Quote Share this post Link to post Share on other sites
Thumper 0 Posted August 15, 2012 Pic of charger Quote Share this post Link to post Share on other sites
Thumper 0 Posted August 17, 2012 Head, fpr, injectors and inlet/tb sold. Tsr manifold reduced to £150 for quick sale :) sns chipped ecu £70 Quote Share this post Link to post Share on other sites
basher 0 Posted October 25, 2012 hi is the chip and pulley and fuel rail still for sale Quote Share this post Link to post Share on other sites
G60_dec 10 Posted October 26, 2012 I will take the rallye u bend gasket if you would sell it separate Quote Share this post Link to post Share on other sites
G60 CS 0 Posted October 26, 2012 (edited) Did the cam sell with the head ? and which SNS chip is in the ecu ? 5 or 5.5 ? Edited October 26, 2012 by G60 CS Quote Share this post Link to post Share on other sites
astraman18 0 Posted October 29, 2012 is the rallye u bend stillfor sale ? what model chip is the sns Quote Share this post Link to post Share on other sites
