Rich the Chef 10 Posted November 25, 2015 Hi. Fitting alloys to my VR6 To get clearance over my caliper carriers and fit the et25 alloys, I've opted for a pair of billet aluminium hub-centric spacers and longer bolts. This should give me about 3/4mm past the carrier. I would like to know if I should be fitting spacers to the rear as well? If so, what width would be needed to keep the geometry correct/even things up? Are hub-centric spacers considered safe for everyday driving? Or are they for show but not go? Thanks in advance. Quote Share this post Link to post Share on other sites
sexybourbon 0 Posted November 25, 2015 Id try gwt the same gap between the arch but it wont make any difference rwally They will be fine mate iv had mine on years with no problems just toghten them up properly Quote Share this post Link to post Share on other sites
Rich the Chef 10 Posted November 26, 2015 Thanks. I've ordered a pair of 10mm with bolts for the fronts and I'll see what I need to level it up at the rear if it looks odd... As long as it's safe I'm happy 👍 Quote Share this post Link to post Share on other sites
