Drive Shaft Heat Shield

[Stone0311 0]

Hi, looking for a driveshaft heatshield for a KR/PG engine - it's the one mounted low down on the back of the block to protect the inner cv joints from the manifold

Thanks

[Simeon 0]

Pretty sure the 3 location bolts are in the same place on all 4 cylinder blocks of the era mate. I definitely have a couple in my lock up, but not sure when I'll next be up there, will check back here to see if you still need one next time I'm up there.

[vw rule 19]

I've had a look on VW ETKA and VW Classic Parts, looks like there's two slightly different part numbers.

 

 

For MK3 Golf / Corrado / Passat 1988 onwards

Part number 357 407 721A

 

Length = 155mm

Width = 140mm

Height = 115mm

 

Bolt holes are at a 45° angle

 

************************

 

For MK3 Golf / Corrado / Passat 1989 onwards

Part number 357 407 721B

 

Length = 145mm

Width = 140mm

Height = 140mm

 

Bolt holes are level parallel

 

 

 

I think most of the 4 cyl Corrado's use

357 407 721B

 

 

Hope this helps

 

Si