Jump to content

Brother Wang

Members
  • Content Count

    2
  • Joined

Everything posted by Brother Wang

  1. You can get replacement 'conversion' arms from VW, straight swap for normal blades, no arm chopping, 2 minutes, job done! Will post the part no's on monday.
  2. I have the same(Ish) problem with my car, same motor and seems to be the same scenario to cause the problem. Have only been driving my first Corrado for about 2 weeks then Monday this week had to go through a moderately flooded section of road. No problems straight after the water, but when i went to use the car in my lunch break (approx5 hours after stopping) Although initially starting well within 20 seconds or so began to lose revs and eventually stall. I restated the car with no problems but again within 20 secs or so the revs began to drop off, i tried to blip them back up with the throttle but the engine would not respond very quickly, coughing and farting slightly, once above 2500/ 3000rpm it seems to run smoothly again, it will then return to idle @ about 8 1/2 -900rpm for a further 20 secs or so then drop off and stall again! I re-started the car and had to keep the revs up to be able to move as below 3k it would just bog down and fart some more, managed to get her on to a nice straight and opened her up, once going she was fine and had no other incidents that day. Wed morning went to leave for work and the same again, started fine, then revs drop and stall. Have checked most of the previously mentioned bits and bobs, leads, elec connections, plugs etc Unsure if i'm looking for a Fuel or electrical problem????? Any ideas???????????????????????????????????? Cheers, Brother Wang x
×
×
  • Create New...