matt buz 0 Posted December 21, 2004 my horn has stopped working? I have checked the fuse and thats fine. Whats next? Ididnt realise how much I used until it went wrong :oops: Quote Share this post Link to post Share on other sites
Supercharged 2 Posted December 21, 2004 Have you taken the centre off the steering wheel? If not do this and unplug it, touch the wires to make the circuit, that will then rule out the switch contacts.... Corrado's have 2 horns so its unlikely they will both stop working at once so must be fuse or connection issue.... Quote Share this post Link to post Share on other sites
Roger Blassberg 0 Posted December 21, 2004 Check that the horns themselves are working by hot-wiring direct from the battery; be careful to use good thick wire because they draw a lot of current which will heat up thin wire very quickly and may burn you. After that, check that the sliding contacts behind the steering wheel are in good order - take the wheel off, clean and reset the spring contact and the copper track mounted on the stalk switch. Also check that the wiring brehind the horn push pad is properly connected. The relay should be your next port of call, somewhere on the fuseboard, I forget which one. Best wishes RB Quote Share this post Link to post Share on other sites
dinkus 10 Posted December 21, 2004 Must...resist...urge...to....make....comment...about....Viagra.. Quote Share this post Link to post Share on other sites
Supercharged 2 Posted December 21, 2004 Must...resist...urge...to....make....comment...about....Viagra.. It affects 1 in 10 of us... (so I've heard) Quote Share this post Link to post Share on other sites
matt buz 0 Posted December 22, 2004 Must...resist...urge...to....make....comment...about....Viagra.. It affects 1 in 10 of us... (so I've heard) Did you hear that off your doctor? :D Cheers all for the advice I will take a look this weekend as it gives me something to do other then stuff my face with a cadburys selection box Quote Share this post Link to post Share on other sites
