potatonet 0 Posted July 25, 2005 how do I check if its bad and what should it read (on the CO pot), also will it read anything with the wire unplugged or do I have to go out and get a wiring adapter thing? sorry guys I dont have a gas analyser. Quote Share this post Link to post Share on other sites
h100vw 0 Posted July 25, 2005 The outer 2 pins should read around 5-600 ohms. Gavin Quote Share this post Link to post Share on other sites
MK1G60R1 0 Posted July 25, 2005 It should go up and down the ohm readings smoothly when you adjust it... Quote Share this post Link to post Share on other sites
W3RKD 0 Posted July 25, 2005 if the reading is over 2k its time for the bin also if it dosent adjust the resistence when you turn the scew it's again ready for the bin Quote Share this post Link to post Share on other sites
potatonet 0 Posted July 26, 2005 RGR THAT! you guys rock my world! =-D Quote Share this post Link to post Share on other sites
potatonet 0 Posted July 27, 2005 it reads about 345 at 750 rpms, which way do I turn it? also is that gonna make it too lean or 2 rich? Quote Share this post Link to post Share on other sites
W3RKD 0 Posted July 27, 2005 `thats rich so i would lean it off a little using a largeish flat blade and a multi-meter turn it untill the meter reads 600 Quote Share this post Link to post Share on other sites
potatonet 0 Posted July 27, 2005 excellent, better gas milage... will this deplete my HP? if yes then =-( Quote Share this post Link to post Share on other sites
