corrado_16v 0 Posted February 9, 2006 If i fitted a 50mm inlet manfold to my 1.8 16v rado wud it work ok?? cus ive read some were that it will lower the torque and it will be slugish untill 5k rpm is this right?? Quote Share this post Link to post Share on other sites
CorradoVR6-Turbo 0 Posted February 9, 2006 You wont loose enough torque to notice but you will have better top end power.If you dont like it change it back, it only takes two ticks...but i bet you wont :wink: Quote Share this post Link to post Share on other sites
corrado_16v 0 Posted February 9, 2006 Thx alot dude il put it on over the weekend see how it gose :D Quote Share this post Link to post Share on other sites
flusted 0 Posted February 10, 2006 Against my relegion,i fitted 1 to mine yesturday. Definatly lost torque in the mid range and i find when you change from 1st to 2nd it takes a while longer before the engine picks up again. Mine was heavily ported and polished aswell,proberly more suited to a 2l as they have more torque to compensate? Quote Share this post Link to post Share on other sites
corrado_16v 0 Posted February 10, 2006 Mine is ported and polished as well i got mine done at cosworth so i know thay have done a good job of doing it :-P i will stick it on and see what i think if i dont like it il put my old one back on and sell it Quote Share this post Link to post Share on other sites
