Alignment on a corrado

[rmn 0]

does anybody have, or know where i would get the measurements to check the alignments!

I know my project was whacked, but before it goes to the body shop i want to make sure the shell is reasonably straight!

Thanks

[Mike Edwards 0]

Well:

 

Front strut tower centre distance = 1087mm.

Front chassis leg seperation = 935mm (measured at front inner edge, at the mid point curved strengthener)

Door aperture = 1100mm (measured horizontally at the widest point)

Rear strut tower centre distance = 1107mm

Tailgate aperture = 1094mm (measured horixontally at widest point)

Tailgate aperture = 950mm (measured on body centreline)

B-pillar seperation = 1374mm (measure horisontally at the rear edge of the door aperture)

 

HTH.

[rmn 0]

Thanks Mike, does the B pillar seperation get measured at the base or not?

Its Around the sills and b post i am curious about

[Mike Edwards 0]

The widest point should be near the mounting for the lock pin on the pillar - about half-way up.

 

There are a load of measurements given in the Bently manual for the underside of the chassis, but no easy way to describe them.

[rmn 0]

Bently it is then! cheers