Window & Mirrors not working when doors are closed

[hipcity 10]

Hi - just had some welding done on the car - Rear drivers side wheel arch.

 

Not sure what has happened or if the cables were not connected correctly - but the windows and mirrors no longer work when the doors are closed?

 

it looks to stop working when the door switch is pushed in - the one that turns of the interior light on/off

 

any ideas - i had a look in the boot and the cables all look ok - i found a fuse box in behind the side panel and a foam box in the boot, but not sure what thet are for

[Rams 0]

Check fuses first, welding may have blown the fuse? Usually you put a safety device onto the battery when welding

[Portent 0]

So if you leave the doors open and don't press the door interior light switch then do the windows and mirrors work?

[hipcity 10]

So if you leave the doors open and don't press the door interior light switch then do the windows and mirrors work?

 

hi, the windows work when i leave the door open and i leave the light switch alone

[joby 0]

there is a regulator unit behind the drivers side rear quarter panel, this will probaly be you fault, had the same with mine, replaced it with a second hand one and it was fine then

[hipcity 10]

there is a regulator unit behind the drivers side rear quarter panel, this will probaly be you fault, had the same with mine, replaced it with a second hand one and it was fine then

 

Hi, there looks to be a lot of wires going to that regulator, what all does it do?

 

Also, would you have any idea what the foam box is within the boot, it sits over the fuel funnel, and contains a plastic box?

 

Thanks

[Wullie 1]

Vacuum pump for the central locking.

[hipcity 10]

It was fuse 14, that needed replaced, thanks for the replies guys

Phil

 

---------- Post added at 08:22 PM ---------- Previous post was at 08:22 PM ----------

 

It was fuse 14, that needed replaced, thanks for the replies guys

Phil