Redfox 10 Posted June 9, 2012 (edited) Hi all, I have the old G60 1991 old wirenet. I don't have the two seperate extra gauges for the centerconsole, but I do have the new two-in-one version from the VR6. I managed to get a bit of the wirenet from that car too. No idea how to connect it, so I can read out the oil pressure and voltage. I read old threads, but didn't get much wiser. The VR6 gauges have a 4 leg connector. I have that piece on the wireing from the car. I do not know if there's anything that I can connect it to in my car. Any good ideas and how and what to do? What about the engineconnection? I think I read something about an extra unused wire floating around in close to the oilfilter or somewhere around that area? As I can see it from the plug behind the VR6 gauges, there's a black/yellow, a brown, a blue/grey and a blue/yellow. This is on picture 1 here: [ATTACH=CONFIG]65405[/ATTACH] The brown from this end goes into a unified multi brown, that becomes a bit thicker and goes along with the blue/grey into a black connector as in picture 2 here: [ATTACH=CONFIG]65409[/ATTACH] then the blue/yellow goes from the VR6 extra gauges into it's own yellow connector as in picture three here: [ATTACH=CONFIG]65413[/ATTACH] And the last wire the black/yellow goes into the big flat blue connector, which can be seen in picture 4, here: [ATTACH=CONFIG]65417[/ATTACH] I am not 100% sure of this, but it looks like it. All help is very much appreciated, as I am a nerd in electrics, and I really would like this to be connected as per original, if there's any chance of that. Thanks, Redfox. Edited June 9, 2012 by Redfox Quote Share this post Link to post Share on other sites
